Duraluminum. CSI 3-Part Specifications.

DURALUMINUM DETAILS AND SPECIFICATIONS

1. Scope

1.1 Product
Furnish Duraluminum Model ____ as manufactured by Porta-King Building Systems, or pre-approved equal.

2. Materials 

2.1 Product Construction
Building to have satin anodized aluminum exterior. All anodized aluminum surfaces to carry a five (5) year warranty from surface deterioration caused by oxidation. Overall height to be 87" for interior use, or 90" with exterior roof.

2.1.1 Fasteners to be corrosion-proof type and to permit on-site replacement of damaged components. Welded fabrication is not acceptable.

2.2 Structural Framework
Structural members to be alloy 6063T6, anodized 204R1, with ribbed pattern.

2.3 Wall panels
Wall panels to be 5/8" high-impact resistant, moisture resistant and expansion resistant insulating REDEX board. Wall panels to carry a five (5) year warranty from swelling due to moisture absorption.

2.4 Finish
Anodized diamond embossed sheer laminated to the exterior side. Interior to have vinyl walnut wood grain surface.

2.5 Floor Structure
Floor to be 1 1/2' solid waterproof insulating core fit tight against wall panels and fastened to bottom structural base frame. Finished floor to be 3003 TREADBRITE aluminum safety treadplate.

2.6 Ceiling
Ceiling panel to be 3/4" REDEX board with white vinyl permanently laminated to the interior side. Ceiling panel to carry a five (5) year warranty from swelling due to moisture absorption.

2.7 Doors
Doors to be of anodized aluminum, 1 3/4" thick, half-glazed with clear tempered safety glass. Bottom portion to include insulated panel with smooth anodized aluminum on both sides.

2.7.1 Sliding door to be top suspended in overhead track assembly and shall be fully weatherstripped. Sliding doors to incorporate a maximum security laminated hookbolt deadlock with removable cylinders. Door to be recessed into the floor structure.

2.7.1. Swing door to be fully weather-stripped with key-in-knob lockset.

2.7.2 Transaction booths to have a horizontal sliding cashier window in the door.

2.8 Windows
Windows to have anodized aluminum frames and to be of industrial quality with active window panel to slide horizontally on stainless steel, ballbearing rollers (plastic rollers are not acceptable). Windows to include inside positive camlocking device. Exterior window sill height to be 38" (inside 34" from finished floor).

2.9 Glass-Glazing
All glazing to be tempered / safety glass.

2.10 Counter
Furnish 22" deep, full width counter, per plans, 32" from finished floor and with walnut grain plastic laminate to match interior walls.

2.11 Electrical Service
All components to be are UL label. Electric service to include single phase, 100 AMP capacity load center, pre-wired in conduit, with one (1) 230v and four (4) 115v circuit capability. Furnish one (1) 115v duplex and one (1) 230v single outlets. Electric work to be in conformation with the NEC. Provide one (1) 6" x 12" conduit access cutout, with removable cover, in the floor.

2.11.1 Lights to be fluorescent type fixtures with acrylic lens.

2.12 Exterior Roof
Exterior weatherproof roof to include a ribbed anodized fascia trim, with integral, self-contained gutters and to include a 3" overhang with a 4" fascia. Roof to be shipped installed.