ASD001. CSI 3-Part Specifications.

MODULAR RAMP SPECIFICATION, 1A, .5 TO 1.5 FLUSH

ASD001 Rev May 1995

SPECIFIER NOTE:

THE FOLLOWING DATA IS INTENDED TO ASSIST IN SPECIFYING PEMKO

PRODUCTS. INCORPORATE IN A PROJECT SPECIFICATION WHERE

APPROPRIATE.

CAREFULLY REVIEW TO ENSURE COORDINATION WITH ALL CONTRACT

DOCUMENTS.

1. PRODUCT: MODULAR RAMP THRESHOLD ASSEMBLIES, FLUSH APPLICATION

(1/2" TO 1-1/2" OFFSETS)

2. MANUFACTURER:

PEMKO * Ventura PEMKO * Memphis

4226 Transport Street 5535 Distribution Drive

Ventura, CA 93003 Memphis, TN 38141

Phone: (800) 283-9988 Phone (800) 824-3018

Fax: (800) 283-4050 Fax: (800) 243-3656

3. MATERIAL & FINISH:

SPECIFIER NOTE:

PRODUCT SELECTED IS AVAILABLE IN MATERIALS & FINISHES SPECIFIED

BELOW. WHERE MORE THAN ONE MATERIAL IS LISTED FOR A PRODUCT,

SELECT PARAGRAPH FOR MATERIAL YOU WANT.

EDIT BRACKETED TEXT TO SPECIFY FINISH. DELETE TEXT NOT DESIRED.

MATERIALS & FINISHES NOT LISTED MAY BE AVAILABLE BY SPECIAL

ORDER.

RAMP COMPONENTS:

NOTE: PEMKO STRONGLY RECOMMENDS PemKote SKID RESISTANT SURFACE

FOR ALL MODULAR RAMP THRESHOLD ASSEMBLIES. THIS RUGGED ABRASIVE

FINISH IS EXTREMELY SKID AND CORROSION RESISTANT AND CARRIES A

10-YEAR GUARANTEE.

Aluminum, Extruded

* Alloy Type 6063-T5

* Chemical and physical properties per the Aluminum

Association, Inc.

* Federal Specification QQ-A-200/9C.

* [Mill Finish, A; PemKote . AK]

MITER RETURN "WINGS" and EXTENSIONS

Aluminum, Cast

* Alloy Type 6061-F

* Chemical and physical properties per the Aluminum

Association, Inc.

* Federal Specification QQ-A-367.

* [Mill Finish, A; PemKote , AK]

4.TEST & CODE COMPLIANCE:

Handicapped: Complies with CABO/ANSI A117.1-1992; ADA

1990;ADAAG 1991 Guidelines.

Fire Label: Classified By UL For Application To Swinging

Type Fire Doors of the Hollow Metal or Steel

Covered composite type Rated up to 3 Hours, or

Wood Core Fire Doors rated up to 1-1/2

Hours Listed and Labeled as Gasketing

Materials. Tested in accordance with UL10B

by Underwriters Laboratory, Inc. .

5.INSTALLATION:

Installation to be performed in strict accordance with

manufacturers instructions furnished with product.

Ramp Sections: Trim or cope if required. Fasten with No.

10 stainless steel flat head screws provided and

appropriate anchors. Use sealant or compound at all

joints.

Miter Return "Wings": Cut to length as required. Fasten

to ramp component with screws provided. Use sealant or

compound at all edges and joints.

6 WARRANTY:

Guaranteed by manufacturer against defects in material

or workmanship for three years.PemKote Skid-Resistant

surface is guaranteed for 10 years.