375. CSI 3-Part Specifications.

375CR SPEC 375 Rev May 1995

SPECIFIER NOTE:

THE FOLLOWING DATA IS INTENDED TO ASSIST IN SPECIFYING PEMKO

PRODUCTS. INCORPORATE IN A PROJECT SPECIFICATION WHERE

APPROPRIATE.

CAREFULLY REVIEW TO ENSURE COORDINATION WITH ALL CONTRACT

DOCUMENTS.

1. PRODUCT: Rigid Jamb Weatherstrip with Closed Cell Sponge

Neoprene Seal (7/16" x 2-1/8"), Pemko

#375CR

2. MANUFACTURER:

PEMKO * Ventura PEMKO * Memphis

4226 Transport Street 5535 Distribution Drive

Ventura, CA 93003 Memphis, TN 38141

Phone: (800) 283-9988 Phone (800) 824-3018

Fax: (800) 283-4050 Fax: (800) 243-3656

3. MATERIAL & FINISH:

SPECIFIER NOTE:

PRODUCT SELECTED IS AVAILABLE IN MATERIALS & FINISHES SPECIFIED

BELOW. WHERE MORE THAN ONE MATERIAL IS LISTED FOR A PRODUCT,

SELECT PARAGRAPH FOR MATERIAL YOU WANT.

EDIT BRACKETED TEXT TO SPECIFY FINISH. DELETE TEXT NOT DESIRED.

MATERIALS & FINISHES NOT LISTED MAY BE AVAILABLE BY SPECIAL

ORDER.

HOUSING:

Aluminum, Extruded

* Alloy Type 6063-T5

* Chemical and physical properties per the Aluminum Assoc., Inc.

* Federal Specification QQ-A-200/9C

* [375CR Clear anodized, 375DR Dark bronze anodized,

375GR Gold anodized].

Architectural bronze (brass), Extruded

* CDA alloy 38500 (56.5% Copper, 2.75% Lead, 40.7% Zinc,

0.05% alum.)

* [365BR Mill finish, Oxidized & oil rubbed, Polished, Satin

brush]

SEAL:

Neoprene, Expanded, Closed Cell

* ASTM D1056-85 Type 2C2

* Mil-R6130C Type II Grade C

* -67 F. to +170 F.

4. TEST & CODE COMPLIANCE

Fire Label: Classified By UL For Application To Swinging

Type Fire Doors of the Hollow Metal or Steel

Covered composite type Rated up to 3 Hours, or

Wood Core Fire Doors rated up to 1-1/2 Hours.

Listed and Labeled as Gasketing Materials.

Tested in accordance with UL10B by

Underwriters Laboratory, Inc. .

Smoke Label: Smoke tested by WYLE Laboratories in accordance

with UL 1784-90; meets the requirements of NFPA

105.

5. INSTALLATION:

Installation to be performed in strict accordance with

manufacturer's instructions furnished with product.

Trim and fasten to header stop first, then trim and attach to

jambs, ensuring contact at threshold. Carefully miter or cope

at corners to ensure tight joints and continuous seal. Install

screws in center of slots. Press lightly against door to

assure good seal. Note: Do not over tighten - installer should be

able to slip business card between seal and door. After best seal

attained, tighten screws.

6. WARRANTY:

Guaranteed by manufacturer against defects in material or

workmanship for 3 years.