321SS. CSI 3-Part Specifications.

321SSN SPEC 321SS Rev May 1995

SPECIFIER NOTE:

THE FOLLOWING DATA IS INTENDED TO ASSIST IN SPECIFYING PEMKO

PRODUCTS. INCORPORATE IN A PROJECT SPECIFICATION WHERE

APPROPRIATE.

CAREFULLY REVIEW TO ENSURE COORDINATION WITH ALL CONTRACT

DOCUMENTS.

1. PRODUCT: Door Sweep, Stainless Steel with Neoprene Seal

(1-15/16" x 3/16") Pemko #321SSN

2. MANUFACTURER:

PEMKO * Ventura PEMKO * Memphis

4226 Transport Street 5535 Distribution Drive

Ventura, CA 93003 Memphis, TN 38141

Phone: (800) 283-9988 Phone (800) 824-3018

Fax: (800) 283-4050 Fax: (800) 243-3656

3. MATERIAL & FINISH:

SPECIFIER NOTE:

PRODUCT SELECTED IS AVAILABLE IN MATERIALS & FINISHES SPECIFIED

BELOW. WHERE MORE THAN ONE MATERIAL IS LISTED FOR A PRODUCT,

SELECT PARAGRAPH FOR MATERIAL YOU WANT.

EDIT BRACKETED TEXT TO SPECIFY FINISH. DELETE TEXT NOT DESIRED.

MATERIALS & FINISHES NOT LISTED MAY BE AVAILABLE BY SPECIAL

ORDER.

DOOR SWEEP:

Stainless Steel

* Type 430

* Roll formed

* [321SSN Bright finish].

SEAL:

Neoprene, Solid, Extruded

* ASTM D2000-90 M2BC 507

* Mil-R-6855 Class 2 Grade 40

* Mil-R-6855 Class 2 Grade 50

* -67 F to +170 F.

4. TEST & CODE COMPLIANCE:

Fire Label: Classified By UL For Application To Swinging

Type Fire Doors of the Hollow Metal or Steel

Covered composite type Rated up to 3 Hours,

or

Wood Core Fire Doors rated up to 1-1/2 Hours.

Listed and Labeled as Gasketing Materials.

Tested in accordance with UL10B by

Underwriters Laboratory, Inc. .

Smoke Label: Labeled as Gasketing for Smoke Control Doors.

Tested per NFPA 105 by Wyle Laboratories

5. INSTALLATION:

Installation to be performed in strict accordance with

manufacturer's instructions furnished with product.

Cut housing to door width. Trim neoprene seal to 1/16" longer than

the trimmed housing on each end. Locate at door bottom and insure

seal with threshold. Fasten with #6 x 5/8" sheet metal screws

provided. NOTE: Not recommended for in-swinging doors..

6. WARRANTY:

Guaranteed by manufacturer against defects in material or

workmanship for 3 years