254X6FG. CSI 3-Part Specifications.

254X226AFGS SPEC 254X6FG Rev May

1995

SPECIFIER NOTE:

THE FOLLOWING DATA IS INTENDED TO ASSIST IN SPECIFYING PEMKO

PRODUCTS. INCORPORATE IN A PROJECT SPECIFICATION WHERE

APPROPRIATE.

CAREFULLY REVIEW TO ENSURE COORDINATION WITH ALL CONTRACT

DOCUMENTS.

1. PRODUCT: Panic Exit Saddle w/ Vinyl Thermal Barrier and Silicone

Seal (1/2"x 7/8"x 6-1/8") Pemko #254X226AFGS

PEMKO * Ventura PEMKO * Memphis

4226 Transport Street 5535 Distribution Drive

Ventura, CA 93003 Memphis, TN 38141

Phone: (800) 283-9988 Phone (800) 824-3018

Fax: (800) 283-4050 Fax: (800) 243-3656

3. MATERIAL & FINISH:

SPECIFIER NOTE:

PRODUCT SELECTED IS AVAILABLE IN MATERIALS & FINISHES SPECIFIED

BELOW. WHERE MORE THAN ONE MATERIAL IS LISTED FOR A PRODUCT,

SELECT PARAGRAPH FOR MATERIAL YOU WANT.

EDIT BRACKETED TEXT TO SPECIFY FINISH. DELETE TEXT NOT DESIRED.

MATERIALS & FINISHES NOT LISTED MAY BE AVAILABLE BY SPECIAL

ORDER.

THRESHOLD:

Aluminum, Extruded

* Alloy Type 6063-T5

* Chemical and physical properties per the Aluminum

Association, Inc.

* Federal Specification QQ-A-200/9C

* [254X226AFGS Mill finish, 254X226DFGS Dark bronze anodized,

254X2GFGS Gold anodized].

Architectural bronze (brass), Extruded

* CDA alloy 38500 (56.5% Copper, 2.75% Lead, 40.7% Zinc,

0.05% alum.)

* [254X226BFGS Mill finish, Oxidized & oil rubbed, Polished,

Satin brush]

VINYL THERMAL BREAK:

Vinyl, Rigid, Extruded Geon (Virgin material)

* Geon is a registered trade mark of the Geon Co.

* ASTM D1784-90 Class 16344

SEAL:

Silicone Rubber, Extruded

* Federal Specification ZZ-R-755 Class 2A Grade 60 Type I & II

* -100 F. to +400 F

4. TEST & CODE COMPLIANCE:

Smoke Label: Smoke tested by WYLE Laboratories in accordance

with UL 1784-90; meets the requirements of NFPA

105-1989..

5. INSTALLATION:

Installation to be performed in strict accordance with

manufacturer's instructions furnished with product.

Carefully cope to fit within the frame opening. Trim seal to

1/16" longer than trimmed threshold on each end.Press against door

to assure good seal, (do not over tighten - installer should be able

to slip business card between seal and door).Fasten with flat

head wood or machine screws provided and appropriate anchors

as required. Use a sealant or compound at all edges and joints.

6. WARRANTY:

Guaranteed by manufacturer against defects in material or

workmanship for 3 years.