18400. CSI 3-Part Specifications.

18400CP SPEC 18400 Rev May 1995

SPECIFIER NOTE:

THE FOLLOWING DATA IS INTENDED TO ASSIST IN SPECIFYING PEMKO

PRODUCTS. INCORPORATE IN A PROJECT SPECIFICATION WHERE

APPROPRIATE.

CAREFULLY REVIEW TO ENSURE COORDINATION WITH ALL CONTRACT

DOCUMENTS.

1. PRODUCT: Nylon Brush Weatherstrip (5-3/8" x 3/8"), Pemko #18400CP

2. MANUFACTURER:

PEMKO * Ventura PEMKO * Memphis

4226 Transport Street 5535 Distribution Drive

Ventura, CA 93003 Memphis, TN 38141

Phone: (800) 283-9988 Phone (800) 824-3018

Fax: (800) 283-4050 Fax: (800) 243-3656

3. MATERIAL & FINISH:

SPECIFIER NOTE:

PRODUCT SELECTED IS AVAILABLE IN MATERIALS & FINISHES SPECIFIED

BELOW. WHERE MORE THAN ONE MATERIAL IS LISTED FOR A PRODUCT,

SELECT PARAGRAPH FOR MATERIAL YOU WANT.

EDIT BRACKETED TEXT TO SPECIFY FINISH. DELETE TEXT NOT DESIRED.

MATERIALS & FINISHES NOT LISTED MAY BE AVAILABLE BY SPECIAL

ORDER.

HOUSING:

Aluminum, Extruded

* Alloy Type 6063-T5

* Chemical and physical properties per the Aluminum Assoc., Inc.

* Federal Specification QQ-A- 200/9C

* [18400CP Clear anodized, 18400DP Dark bronze anodized,

18400GP Gold anodized].

NYLON BRUSH:

* Heat stabilized, Nylon Type 6

* UL approved

4. TEST & CODE COMPLIANCE

Fire Label: Classified By UL For Application To Swinging

Type Fire Doors of the Hollow Metal or Steel

Covered composite type Rated up to 3 Hours, or

Wood Core Fire Doors rated up to 1-1/2 Hours.

Listed and Labeled as Gasketing Materials.

Tested in accordance with UL10B by

Underwriters Laboratory, Inc. .

5. INSTALLATION:

Installation to be performed in strict accordance with

manufacturer's instructions furnished with product.

Used for special purpose applications, hanger doors, and overhead

doors. Trim to length required, squeeze ends of brush backing to

retain bristles. Carefully miter or cope at corners to ensure

tight joints and continuous seal. Install screws in center of

slots. After best seal attained, tighten screws.

6. WARRANTY:

Guaranteed by manufacturer against defects in material or

workmanship for 3 years.